I N S T A L L A T I O N
©Vantage, 12/1/2016 / IS-0472-B
RadioLink® EasyTouch II ScenePoint DR — MODEL: RDR1XXX-XXXX
page 4 of 4
Decorah
Ring
Foam
Sealer
Matrix
Base
Diffusers
Buttons
1 to 5
DIFFUSERS
BUTTONS
TWO & THREE BUTTON
DIFFUSERS 1, 3, 4 & 5
FOUR & EIVE BUTTON
ALL DIFFUSERS 1 – 5
Changing the Number of Buttons
EasyTouch II dual-relay ScenePoints will support 2 to 5 buttons. The number of buttons may be changed on a keypad after it has been installed
by following these instructions.
Turn the circuit breaker off and make sure no voltage is present at the ScenePoint station being modifying
.
1.
Change the software file to the new number of buttons with proper engraving.
2.
Order the new buttons for proper engraving.
3.
Disconnect power from the station
4.
Replace the old button configuration with the new button configuration using the chart example below.
5.
When finished replacing the buttons and the station is fully assembled, test the
new buttons operation.
Proper Button Assembly of EasyTouch II Stations
Disassemble:
1.
Faceplate: Remove faceplate.
2.
Decorah Ring: Remove Decorah button ring.
3.
EasyTouch II Buttons: Remove buttons that need replaced.
4.
LED Button Diffuser:
Remove
or
add
diffusers for new button
configuration, using the examples below.
Assemble:
1.
LED Diffusers: Double check diffusers are in the correct position.
2.
Buttons: Place buttons in proper positions for new configuration. Buttons
Must be in the correct position following tapered design from top to
bottom. Buttons have a small number on the back border, 1 is top and 5
is bottom.
3.
Decorah Button Ring: Replace, securely snaps in place.
4.
Faceplate: Replace.
Line Draw View
