Vaddio is a brand of Legrand AV Inc.·
· Phone 800.572.2011 / +1.763.971.4400 ·
Fax +1.763.971.4464 · Email
·
Vaddio is a registered trademark of Legrand AV Inc. All other brand names or marks are used for
identification purposes and are trademarks of their respective owners. All patents are protected under
existing designations. Other patents pending.
©2021 Legrand AV Inc.
Installing the Camera and Connecting Power
Caution
Check your cables. Connecting a cable to the wrong port or using the wrong pin-out can result in
equipment damage and will void the warranty.
1. Secure the camera in the mount using the two screws provided.
2. Connect all required cables to the camera.
3. Secure the cable cover to the mount.
4. Connect the mid-span power injector to mains power.
About Inverted Installation
If you install the camera with the connector panel pointing up, you will need to select the camera's Image
Flip setting when configuring behavior and performance. Image Flip orients the video image correctly
and sets the camera to respond appropriately to tilt commands.
Next Steps
The camera is now ready to configure and use. This information is available in the
Complete Manual for
the IntelliSHOT Auto-Tracking Camera
.
Operation, Storage, and Care
For smears or smudges on the product, wipe with a clean, soft cloth. Use a lens cleaner on the lens. Do
not use any abrasive chemicals.
Keep this device away from food and liquids.
Do not operate or store the device under any of the following conditions:
n
Temperatures above 104° F (40° C) or below 32° F (0° C)
n
High humidity, condensing or wet environments
n
Inclement weather
n
Severe vibration
n
Dense asteroid fields
n
Dry environments with an excess of static discharge
Do not attempt to take this product apart. There are no user-serviceable components inside.
Installation Guide for the ConferenceSHOT ePTZ Auto-Framing Camera
