SmartLock Kit Quick Setup Guide - DX2-DH2C2
5
SmartLock_DX2DH2C2_QSG_1G_3.6.10
255-90-0006-00
Settings
•
Click Edit settings.
•
Door Handle Type:
Select your door handle's model.
If your specific Southco H3-EM model is listed, select it. For all other supported Southco H3-EM models, select "Southco H3-EM".
•
Timeout:
Specify how long the
door handle lock
can remain open after someone opens the door handle via a smart card or via remote
control using the software. When the timeout expires, the door handle lock will be automatically closed. Default is 600 seconds (that is, 10
minutes).
•
Door Sensor Polarity:
Choose the correct setting based on the type of contact closure sensors used to monitor the door:
Normally closed: The contact is closed (conducting) when the door is closed and open (not conducting) when the door is open.
Default
.
Normally open: The contact not conducting when the door is closed and conducting when the door is open.
Note: For both normally closed and normally open sensors, the reported state is "open" when the door is open and "closed" when the door
is closed.
•
Relock on Handle Close:
This setting controls auto-locking of door handles. Select "Only if door closed" to delay auto-locking of door handles
until "Door State" and "Door Lock State" are both verified as "Closed". Select "Always" to relock door handles automatically.
•
Connected Device:
If your door handle has a connected device, such as a keypad, select it from the list.
•
Save your changes.
•
Once the Door Handle State and Type is detected, the information populates in Door state section.
•
Optional: You can rename each Door Handle component by clicking the item and editing settings.