794
You can use either the reset button or the command line interface (CLI)
to reset the PX3.
Important: Exercise caution before resetting the PX3 to its factory
defaults. This erases existing information and customized settings,
such as user profiles, threshold values, and so on. Only active
energy data and firmware upgrade history are retained.
Alternative:
Another method to reset it to factory defaults is to use the web interface.
See
Resetting All Settings to Factory Defaults
(on page 476).
In This Chapter
Using the Reset Button ........................................................................... 793
Using the CLI Command ......................................................................... 794
Using the Reset Button
An RS-232 serial connection to a computer is required for using the
reset button.
To reset to factory defaults using the reset button:
1.
Connect a computer to the PX3. See
Connecting the PX3 to a
Computer
(on page 31).
2.
Launch a terminal emulation program such as Kermit or PuTTY, and
open a window on the PX3. For information on the serial port
configuration, see Step 2 of
Initial Network Configuration via CLI
(on page 912).
3.
Press (and release) the Reset button of the PX3 device while
pressing the Esc key of the keyboard several times in rapid
succession. A prompt (=>) should appear after about one second.
4.
Type
defaults to reset the PX3 to its factory defaults.
5.
Wait until the reset is complete.
The following illustrates the reset button on Zero U PDUs. Port
locations may differ on your models.
Appendix F Resetting to Factory Defaults
Содержание Raritan PX3-3000 Series
