LEGRAND Raritan PX3-3000 Series, Руководство пользователя

Страница: 75 / 977

Chapter 4: Connecting External Equipment (Optional)
54
a. Plug one end of the cable into the remaining RJ-45 port on the
prior DX package.
b. Plug the other end into either RJ-45 port on an additional DX
package.
Repeat the same steps to cascade more DX packages.
Exception: You CANNOT cascade DX-PD2C5 sensor packages. A PX3
supports only one DX-PD2C5.
3. Connect the first DX sensor package to the PX3 by plugging its
cable's connector into the RJ-45 SENSOR port of the PX3.
4. If needed, connect a DPX2 sensor package to the end of the DX chain.
See
Connecting a DPX2 Sensor Package to DX2, DX or DPX3 (on
page 58).
Warning: DX-PD2C5 or DX2-DH2C2, and asset management strip(s)
are mutually exclusive so do NOT connect both of them to the PDU
simultaneously.
DPX3 Sensor Packages
A DPX3 sensor package features the following:

Its connection interface is RJ-45.

You can cascade a maximum of 12 DPX3 sensor packages.
Numbers Components
RJ-45 ports, each of which is located on
either end of a DPX3 sensor package.