www.qmotionshades.com Pensacola FL, 32514 1 -877-849-6070 2
PN 9000217
IMPORTANT
When unrolling the shade
to expose battery cover, the shade will try to roll upward. Hold the
FABRIC ROLL TUBE
firmly in
place to resist the initial upward movement, then continue to unroll the
FABRIC ROLL TUBE
to expose battery cover.
BATTERY REPLACEMENT
1. PRESS
and
RELEASE
the
DOWN
button (Shade will move to Lower Limit Position)
2. UNROLL
the
FABRIC ROLL TUBE
to expose the battery cover (See
IMPORTANT
information above)
3. REMOVE
battery cover and
REPLACE
with new
NEW D-CELL
Alkaline batteries
4. REPLACE
battery cover (Shade will now respond to remote commands)
5. PRESS
and
RELEASE
the
UP
button to roll fabric back onto the tube
FACTORY (MASTER) RESET
(Will remove
ALL
paired remotes)
(Shade at Upper Limit Position)
1. Use a paperclip to
PRESS
the
PROGRAM
button on back of the remote
(The channel LEDs will scroll back and forth when in program mode)
2.
PRESS
and
HOLD
the
DOWN
button
UNTIL
the shade moves downward and JOGs
3.
TUG
the shade
6-10 inches
(Shade will JOG in response)
SETTING UPPER AND LOWER LIMITS / LEARNING A NEW POSITION
1. PRESS
and
RELEASE
the
(UP, DOWN,
or
PRESET)
button that will be programmed
__
(Shade will move to selected position)
2. PRESS
and
HOLD
the same
(UP, DOWN,
or
PRESET)
button
UNTIL
the shade
JOGS
3. TUG
shade
6-10 inches
(Shade will JOG in response)
4. ADJUST
shade to desired position (Manually roll shade by hand if necessary)
5. PRESS
and
HOLD
the same
(UP, DOWN,
or
PRESET)
button (Shade will JOG when learned)
DELETE / UNLEARN A REMOTE
(or Channel)
(Shade at Upper Limit)
1. PRESS
and
RELEASE
the
CHANNEL
button to select the channel currently paired to the shade
__
(Skip channel selection for Single-Channel Remotes)
2.
Use a paperclip to
PRESS
the
PROGRAM
button on back of the remote
(The channel LEDs will scroll back and forth when in program mode)
3. PRESS
and
HOLD
the
UP
button until Shade moves downward
4. TUG
the shade
6-10 inches
(Shade will JOG in response)
5.
Use a paperclip to
PRESS
the
PROGRAM
button on back of the remote
(The channel LEDs will scroll back and forth when in program mode)
6. PRESS
the
DOWN
button
(Shade will JOG, move to Upper Limit Position, then JOG again)
IMPORTANT
Lower Limit Position must be set prior to using the
PRESET
positions
(20%, 40%, 60%, 80%)
. These positions are based on
the Lower Limit Position of the shade. When learning new positions, the button currently being programmed (after Step 3.
TUG) will not send commands to the shade. After Step 5 all buttons resume full functionality.
Example 1:
When learning a new Upper Limit Position, the
UP
button is semi-disable. Only by pressing the
UP
button
3
times
will the shade move to the up position (or manually roll the shade up by hand).
Example 2:
When learning a new Lower Limit Position, the
DOWN
button is disabled. The shade can still be adjusted using
the
UP
button (or manually roll the shade by hand).