www.qmotionshades.com Pensacola FL, 32514 1 -877-849-6070 1
PN 9000217
Qadvanced Roller Shade
Gen. 3
Programming Instructions
12345
CH
Multi-Channel QdR Remote
Remote Back
UP
DOWN
CHANNEL
20%
40%
60%
80%
PROGRAM
Pin Hole
Read and understand each section before performing required steps
During
FIRST TIME SETUP
after
Step 3. TUG
, a remote must be paired to the shade within 90 seconds. Otherwise, the shade
will time-out and require a Special Learn Command (Pg. 1)
to pair a new remote. JOG is a short up and down movement.
Channel number is indicated on the remote by a single green LED. The “ALL
”
channel (all 5 green LEDs illuminated) follows
Channel 5 in the selection sequence. Shade will only respond to learned channel, or “ALL” channel.
IMPORTANT
FIRST TIME SETUP
1. INSTALL SHADE
following appropriate instructions
2. PRESS
and
RELEASE
the
CHANNEL
button to select a channel
(1-5)
__
(Skip channel selection for Single-Channel Remotes)
3. TUG
the
HEMBAR
6-10 inches
(Shade will JOG in response)
4.
Use a paperclip to
PRESS
the
PROGRAM
button on the back of the remote
(The Channel LEDs will scroll back and forth when in program mode)
5. PRESS
and
RELEASE
the
UP
button
__
(Shade will JOG, move to Upper Limit Position, then JOG again)
SETTING LOWER LIMIT
1. PRESS
and
RELEASE
the
DOWN
button
__
(Shade will move to current Lower Limit Position)
2. PRESS
and
HOLD
the
DOWN
button until shade
JOGS
3. TUG
the
HEMBAR
6-10 inches
(Shade will JOG in response)
4. ADJUST
shade to desired Lower Limit
__
(The DOWN
button is disabled while setting the Lower Limit, adjust by pressing the
___
UP button or manually roll shade by hand)
5. PRESS
and
HOLD
the
DOWN
button until shade
JOGS
SPECIAL LEARN COMMAND
(Shade at Upper Limit Position - manually roll shade up by hand if necessary)
1.
Use a paperclip to
PRESS
the
PROGRAM
button on the back of the remote
(The channel LEDs will scroll back and forth when in program mode)
2. PRESS
and
HOLD
the
CHANNEL
button until the shade moves
3. TUG
the
HEMBAR
6-10 inches
__
(The shade will JOG in response)
4.
Use a paperclip to
PRESS
the
PROGRAM
button on the back of the remote
(The channel LEDs will scroll back and forth when in program mode)
5. PRESS
and
RELEASE
the
UP
button
(Shade will JOG, move to Upper Limit Position, then JOG again)
Use Special Learn Command when:
- The shade times-out without being paired to a remote.
- A paired remote is not being used or available
- Adding a second remote to the shade
Single-Channel QdR Remote
(Channel Numbers Not Labeled)
UP
DOWN
20%
40%
60%
80%