1
www.qmotionshades.com Pensacola FL, 32514 1 -877-849-6070
PN 9000225
Qadvanced Roller Shade
ZigBee HA1.2
Programming Instructions
Read and understand each section before performing required steps
Refer to appropriate user manual whenever a
QMotion Gateway/Router
is
NOT
used to establish the ZigBee network.
Instructions for allowing Routers and End Devices to join the ZigBee HA1.2 network will vary by manufacturer.
IMPORTANT
Network
Button
Micro USB
Port
LED
Range Extender
ZigBee Router
CREATE A NEW NETWORK
(Range Extender)
1. POWER
the
RANGE EXTENDER
using the provided
__
power supply (Should be centrally located to shades)
2. PRESS
and
HOLD
the
NETWORK
button until the
__
GREEN LED
illuminates (Green LED illumination
__
indicates the network is active)
ADD REMOTE TO NETWORK
1. PRESS
and
RELEASE
the
NETWORK
button on the
__
RANGE EXTENDER
__
(Red LED will pulsate on network coordinator/routers )
2. PULL
BATTERY TAB
from Remote
3.
Use a paperclip to
PRESS
the
PROGRAM
button on
__
back of the remote
(The channel LEDs will scroll back and forth when in
__
program mode)
4. PRESS ANY BUTTON
on the remote to join network
__
(Green LED will flash when remote joins the network)
ADD SHADE TO NETWORK
1. PRESS
and
RELEASE
the
NETWORK
button on the
__
RANGE EXTENDER
__
(Red LED will pulsate on network coordinator/routers )
2. TUG
the
HEMBAR
6-10 inches
__
(Shade will JOG in response)
PAIR REMOTE TO SHADE
1. PRESS
and
RELEASE
the
CHANNEL
button
to select
__
the channel that will control the shade
2. PRESS
the
PROGRAM
button on the back of the remote
3. PRESS
and
RELEASE
the
UP
button
__
(Shade will JOG in response)
4. TUG
the
HEMBAR
6-10 inches
__
(During Step 3, multiple shades can be tugged to learn
__
the same remote)
Range Extender:
Green LED will flash rapidly for 1 sec-
ond when a device (Shade/Remote) joins the network
ADD RANGE EXTENDER TO ZIGBEE NETWORK
1. PRESS
and
RELEASE
the
NETWORK
button on the first
__
Range Extender that created the ZigBee network
__
(The green
LED will be a solid illumination, the red LED will
___
begin to pulse when the network is open for joining)
2. PRESS
and
RELEASE
the
NETWORK
button on Range
__
Extender to be added to the network
__
(The green LED will illuminate and blink when it has joined
___
the ZigBee network )
3.
The Range Extender green LED will continue to pulse,
__
showing that it has extended the ZigBee network.
DELETE RANGE EXTENDER FROM ZIGBEE NETWORK
1. PRESS
and
RELEASE
the
NETWORK
button
3 times
__
quickly
__
(The green LED will stop illuminating)
These instructions are for building a simple-Stand alone network, where no Qube or other control Gateway is used.
