REVERSING THE DOOR
Page 15
REMOVING LEVER LOCK PLATE AND CHANNELS
NOTE
: Your FlexView Conferencing Cart comes with a 10” Lever Lock™ plate (B) and (2x) 2” channels
(C) pre-installed inside. This topic explains how to remove them.
1. Temporarily remove any devices, cables, and cable management from the inside of your cart.
2. Use a flat head screwdriver to pop out Lever Lock securing rivets (J) from your 10” plate (B) and
(2x) 2” channels (C). (
FIGURE V
)
TIP
: Use screwdriver to push the tip end of the rivet, and then pull the head out.
3. Press the clip and lift the same side of the 10” plate and 2” channels from the adapter bracket.
NOTE
: The door on your cart comes
pre-assembled the hinges inserted into holes on
the left side, and the catch is located on the right.
This topic may be used to reverse the door, if
desired.
1. Twist and lift bottom and top hinges
(in that order) and lift the door off your cart.
(
FIGURE U
)
2. Carefully rotate the door and install the top and
bottom hinges (in that order) into the holes on
the other side of your cart.
NOTE
: Adjust torque on power driver to lightest
setting and only increase as necessary.
3. Use power driver and #2 Philips bit to remove
(2x) screws and the catch from the left side of
the cart and install it to the corresponding
location on the right side.
FIGURE U
Bottom
Hinge
Top
Hinge
FIGURE V
J
Clip
Side
with clip
Side
without clip
NOTE
: 10” Lever Lock
plate (B) shown.
