This product may be covered by patents found at www.kenall.com/patents. Content of specification sheets is subject to change; please consult www.kenall.com for current product details.
© 2018 Kenall Mfg. Co. All rights reserved.
www.kenall.com P: 800-4-Kenall F: 262-891-9701 10200 55th Street Kenosha, Wisconsin 53144
2
INSTALLATION INSTRUCTIONS
SA-PM_F-7793_021820
1. Make sure power is off and locked out at the panel.
2. Unbox fixture and set on cardboard oriented with the lens side up.
3. Remove arm cover plate by loosening philips screw and set aside (Do not open the fixture housing). See Figure 2.
4. Prepare pole for mounting by drilling holes per template. See Page 1.
5. For square poles:
A. Assemble 3/8” bolts provided with lock washers and flat washers and insert them through the fixture arm
and then through the square pole adapter. See Figure 1.
B. Apply thread lock adhesive to mounting bracket threads.
C. Align and temporarily secure or otherwise hold the mounting bracket inside the pole with the
holes aligned.
D. Lift fixture with hardware into alignment and tighten bolts to 25 ft-lbs. (300 In-lbs) (* this step may require
more than one person).
6. For round poles
A. Remove v-shaped metal section from fixture mounting arm top and bottom surfaces. (See figure 4)
B. Assemble 3/8” bolts provided with lock washers and flat washers and insert them through the arm as
shown in figure 1. (Do not use the square pole adapter).
C. Apply thread lock adhesive to mounting bracket threads.
D. Align and temporarily secure or otherwise hold the mounting bracket inside the pole with the
holes aligned.
E. Lift fixture with hardware into alignment and tighten bolts to 25 ft-lbs. (300 In-lbs).
Square Pole Adapter
(Not needed for round)
Mounting Bracket
Square Pole
Washer x 2
Lock Washer x 2
3/8" Bolt x 2
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
