www.kenall.com | P: 800-4-Kenall | F: 262-891-9701 | 10200 55th Street Kenosha, Wisconsin 53144, USA
This product complies with the Buy American Act: manufactured in the United State swith more than 50% of the component cost of US origin It may be covered by patents
found at www.kenall.com/patents. Content of specification sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg.Co.
2
INSTALLATION INSTRUCTIONS
F-2935
INSTALLATION (cont’d)
CAUTION: LED Lamps operate at 4VDC ONLY. Fixture
is intended to be powered by external low voltage
regulated power supply. To avoid electrical overload,
use only with Kenall Millenium Metrex series unit
equipment or master exit signs equipped with
remote exit sign power capability.
• Directional Indicators (Fig. 4): Configure
DIRECTIONAL ARROWs as needed. To remove
DIRECTIONALARROW COVER, use 7/16” nut
driver (not supplied) to loosen RETAINER NUT
approx. one complete turn. Push in cover from
outside. Tighten RETAINER NUT to secure COLOR
FILTER PANEL and aluminum LIGHT MASK (if
provided).
•
Minimum 12” supply wire pigtails must
extend from electrical junction box for field
connections within fixture enclosure.
Installation
• Disassembly (Fig.1): Remove SHIELD by
loosening (4) CAPTIVE SCREWS at
corners Remove STENCIL PANEL.
• Mounting Place HOUSING over an installed
electrica junction box (drill points provided
for temporary j-box attachment prior to
permanent mounting). Locate and drill 4
pilot holes in mounting surface using
HOUSING as a template. (Fig.2): For wet
location installation, attach self-adhesive
pad GASKETS to HOUSING at (4) mounting
holes and center wiring hole. Observe correct
orientation of UP indicators molded into
housing. Using ¼” fasteners and anchors
appropriate for the mounting surface (not
supplied), attach HOUSING to structure.
• Wiring (Fig. 3): Route 12” supply wire pigtails
through WIRING ACCESS HOLE. Secure supply
wires with CABLE TIE provided. Connect
supply wires to appropriate terminals in
TERMINAL BLOCK. Lead color coding: Gray=
Negative, Brown=Positive.
