Installation Instructions
TA210E
7
Camera/Component Installation
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all equipment and accessories mounted on the TA210E
brackets does not exceed 10 lbs (4.54 kg) per bracket.
1.
Position camera (not included) inside camera bracket (C) so
that camera mounting holes line up with keyholes on back
of bracket. (See Figure 7)
2.
Use two M4 x 8mm Phillips pan machine screws (J) to
secure camera bracket (C) to camera. (See Figure 7)
Figure 7
3.
Loosely install two M4 x 8mm Phillips pan machine screws
(J) into lower holes on attachment bracket (N). (See Figure
8)
4.
Install camera to attachment bracket by placing keyholes on
camera bracket (C) over screws installed in Step 3. (See
Figure 8)
5.
Tighten screws (J) to secure camera in position. (See
Figure 8)
Figure 8
Adjustments
Height Adjustment
NOTE:
Camera must be removed from mount prior to adjusting
height.
1.
Loosen three 1/4-20 x 5/8" button head cap screws (F)
holding extension bracket (B) or camera bracket (C) to
hanging bracket (A). (See Figure 9)
2.
Adjust height of shelf (C) as desired.
3.
Tighten three 1/4-20 x 5/8" button head cap screws (F)
holding extension bracket (B) or camera bracket (C) to
hanging bracket (A). (See Figure 9)
Figure 9
camera (not included)
2
(J) x 2
1
(C)
(J) x 2
3
4
4
(N)
(N)
(C)
2
1
3
with extension bracket
without extension bracket
2
