LEGRAND Chief Kontour KPWR Series, Руководство по установке

Страница: 4 / 8

KPWR Installation Instructions
4
Assembly And Installation
NOTE:
Y-adapter models ONLY need to add spacer (C) before
installing KPWR to mount. For all other models,
proceed to "KPWR Installation" section.
Add Spacer (Y-adapter models ONLY)
1. Remove bolt, washers and spacers holding mount to base.
(See Figure 1)
2. Reassemble assembly adding spacer (C) on top of existing
spacer and removing plastic washer sandwiched between
two steel spacers. (See Figure 1)
3. Tighten bolt to secure mount to base. (See Figure 1)
Figure 1
KPWR Installation
1. Assemble and attach Kontour™ mount to desk following
installation instructions included with mount.
2. Loosen clamp holding Kontour™ mount to desk by
loosening clamp screw. (See Figure 2)
Figure 2
3. Slide foot plate (B) under top portion of desk clamp, making
sure holes are extruding "up." (See Figure 2)
4. Tighten clamp holding Kontour™ mount to desk by
tightening clamp screw. (See Figure 2)
5. Set KPWR assembly (A) onto top portion of desk clamp.
(See Figure 3)
NOTE:
Magnets on bottom of assembly (A) are designed to
center the accessory in the proper position.
Figure 3
6. Plug cable into power source.
(K1D220 shown)
3 1
2
2
remove
add (C)
steel spacers x 2
2 4
3
(B)
(K2C120 shown)
holes extruding
"up"
7
5
6