Installation Instructions
CSSMP15X10
7
2.
Insert four 5/16-18 x 3/8" button head cap screws (D) into
the two slot nuts (C) and partially tighten. (See Figure 4)
3.
Slide two slot nuts (C) into end of extrusion. (See Figure 4)
Figure 4
CAUTION:
The storage panel must be mounted with the
clip at the bottom. (See Figure 1) and (See Figure 5)
4.
Hold the storage panel (G) over the four button head screws
(D) and lower the storage panel keyholes over the screws.
(See Figure 5)
Figure 5
5.
Tighten screws securely against the storage panel.
Attaching Components
1.
Remove mounting plate from storage panel by pressing
inward on the clip located at the bottom of the storage panel.
(See Figure 6)
2.
Place component(s) on mounting plate and position in the
desired location with the hole pattern in mounting plate best
aligned to component mounting holes. (See Figure 6)
Figure 6
3.
Using the fasteners provided with the component and the
washers (E), attach the component to the mounting plate.
(See Figure 6)
4.
Return mounting plate to storage panel by installing the side
without the clip into the panel first, followed by the side with
the clip until it clicks into place. (See Figure 7)
5.
OPTIONAL:
If desired, install plastic rivet (F) into hole next
to clip to secure the mounting plate in place.(See Figure 7)
Figure 7
(C x 2)
2
2
(D x 4)
(C x 2)
Keyholes
5
(D) x 4
4
Clip
Component
Component
fasteners
3
Mounting
plate
1
(E)
Clip
Clip
5
Side with clip
Side without clip
OPTIONAL
Insert plastic
rivet
