LEGRAND CHIEF CSPR, Руководство по установке

Страница: 8 / 12

CSPS/CSPR Installation Instructions
8
CSPR Installation
1. Position top wall bracket (B) on wall at desired mounting
location. Use a level to ensure of an even mount. (See
Figure 6)
2. Mark and drill four 1/2" (12.7mm) holes at the desired
mounting locations. (See Figure 6)
NOTE:
Any two holes may be used to mount the wall brackets
to the wall as long as they are on opposite sides of the
brackets.
Figure 6
3. Hold metal channel on #10-24 anchor (C) flat alongside
plastic straps and slide channel through hole. (See Figure
7)
Figure 7
4. Holding plastic straps on anchor (C), pull anchor away from
wall until channel rests flush behind wall. (See Figure 8)
5. Slide plastic cap on anchor (C) towards wall until flange of
cap is flush with wall. (See Figure 8)
Figure 8
6. Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 9)
7. Repeat Steps 3 through 6 for the other mounting hole.
Figure 9
8. Use two #10-24 x 1 1/4" Phillips pan machine screws (D)
and two #10 washers (E) to secure wall bracket (B) to
anchors (C). (See Figure 10)
Figure 10
2
1/2" (12.7mm)
(C)
Drywall
Plastic Straps
3
(C)
Plastic Cap
Drywall
SIDE VIEW
4
5
Plastic Straps
Drywall
Plastic Cap
SIDE VIEW
6
(B)
8
(D) x 2
(E) x 2
(C) x 2