Cat. no(s).: 882 30
Configuration tool with screen
Technical data sheet: F01163EN/00
Updated on:
Created on: 23/08/2010
4/5
3. NAVIGATION (continued)
3.2 Instructions for use (continued)
3.2.2. Advanced mode (continued)
D
Loop type
There should be outside light available for proper operation of the Light
regulation.
Closed loop:
the detector measures the light level in its coverage area and regulates the
lighting according to the measurement made.
Open loop:
the detector does not measure the light level in its coverage area.
The lighting is regulated according to the outside light present.
3.2.3 Files
3. NAVIGATION (continued)
3.2 Instructions for use (continued)
3.2.4 PnL sensor
Sensor parameter
Advanced mode
Files
PnL sensor
Files
3
Files
File name
Example
The "Files" menu can be used to display the personalised settings saved.
Up to 26 files can be saved.
Sensor parameter
Advanced mode
Files
PnL sensor
PnL sensor
4
PnL = Push & Learn
Teach mode allowing several products to be joined in a system.
The configuration tool allows this function to be used remotely.
Walk test
Mode used to check how the installation is operating.
When the command is sent, the detector goes into test mode for 5 minutes. The
detector is therefore in Auto ON/Auto OFF mode and the time delay is set at
5 sec.
End time delay
Used for forcing the end of the current time delay.
Initial state
Used for exiting the Test mode and puts the installation into operating mode
(initial state).
This function does not modify the selected parameters.
ON
Used for forcing switch on.
OFF
Used for forcing switch off.
PnL sensor
Add peripheral
PnL group
Del
Learn
Files
PnL sensor
Test
Settings
Test
5
Walk test
End time delay
Initial state
ON
OFF
Note:
All technical information is available at
www.legrandoc.com
Note:
All technical information is available at
www.legrandoc.com
Note:
All technical information is available at
www.legrandoc.com
xx H xx MIN xx Sec
PIR > High
US > Low
Closed loop
xxx Lux
x Lux
Light regulation
Mode
Detection scheme
Detection scheme
Detection scheme
Alert
Time delay
Sensitivity
Sensitivity
Loop type
Daylight setpoint
Provision of light
Enabled/Disabled
Walkthrough
Initial > PIR only
Maintain > PIR only
Retrigger > PIR only
Enabled/Disabled
3.2.5 Test
A
Learn
End
Ok
+
-
A
Adds a channel
to the group
Deletes a channel
from the group
Finishes the procedure
Switches
to the next
channel