LEGRAND 430 523, Руководство пользователя

Страница: 25 / 91

DIP SWITCH SETUP
Before in
stalling the camera, set up the DIP switch to configure the camera ID and the communication protocol.
DID numbers of cameras are set up with binary numbers. See the examples shown below. •
Pin 1 2 3 4 5 6 7 8
Binary
Value
1 2 4 8 16 32 64 128
ex: ID = 5
ex: ID = 10
on
off
off
on
on
off
off
on
off
off off
off off
off off
off
The camera ID range is “1~255”. • Camera ID must not be “0”!
The factory default of the camera ID is “1”. •
Match the camera ID with the Cam ID setting of your DVR or Controller to control the camera. •
If you are connecting a single camera to a controller, terminate the camera. When connecting more than one •
camera to a single controller, terminate the last camera on the communication line. The last camera means
the camera farthest in cable length from the controller.
Note that the total length of the communication cable between a controller and the camera(s) on the same
•
communication line must be less than 1.2Km.
Camera ID Setup •
25