3/5
Connected energy meter
Cat. number : 4 120 15
4. PREPARATION - CONNECTION
(
continued
)
Real-time and historical data visualization:
. Via smartphone with the Home+Control app.
Visualization of the setup of the device:
. Via the LED on the front face
Color
Status
Signification
Red
Fixed
Temporary status. Device not
connected to the radio
network
Green
Fixed
Temporary status. Device
correctly paired to the radio
network (when the radio
network is still open)
OFF
Normal status. Device paired
to the radio network (when
the radio network is closed)
Add a Connected Contactor in a connected installation
(several steps):
.
1/
Beforehand, to create a connected installation you must
install:
Either a gateway module
Or a connected starter pack (drawing of principle, works with
any
kind of “
with Netatmo
”
connected starter pack).
4. PREPARATION - CONNECTION
(
continued
)
.
2/
Beforehand, the general circuit breaker must be turned OFF,
and only after wiring step done, can be powered back ON to
simultaneously power devices and allow them to be connected to
the network.
.
3/
Press and hold the gateway module settings button for more
than 3 seconds, OR in the center of the Home / Away wireless
master switch until the LED turns green, then release the button.
. The configuration LEDs of " ... with Netatmo " devices in the
installation must all light up in fixed green.
.
4/
To complete the installation, briefly press the setting button
on the gateway module (or in the center of the Home / Away
wireless master switch) to finalize the installation.
All " ... with Netatmo " devices LED go OFF
Technical data sheet: F03108EN/02
Updated on: 16/11/2020
Created on: 14/01/2020
