6/6
Miniature PIR presence detector - DALI dimming
Technical data sheet: S000104982EN-3
Updated: 03/02/2021
Created: 25/10/2018
Cat. No(s): 0 489 53
8. TROUBLESHOOTING
1. If the load does not turn ON
- Check that the live supply to the circuit is correct.
- Check that the load is functioning by bypassing the sensor (link
terminals L and L/Out).
- If the detection range is smaller than expected, see the Performance
section. Rotating the sensor slightly may improve the detection range.
2. If the load does not turn OFF
- Ensure that the area is left unoccupied for longer than the timeout
period.
- Ensure that the sensor is not affected by draughts, heaters or lamps.
3. In the event of “false tripping”, reduce the sensitivity settings.
4. If the light level is often too low
- Increase and adjust the value of the “Lux level for regulation”
parameter: from 150 up to 200.
- Adjust the value of the following parameters:
• Lux On level = Lux level for regulation - 5
• Lux Off level = Lux level for regulation x 1.5
Example:
- Lux level for regulation = 180
- Lux On level = 175
- Lux Off level = 270
- Lux Off time = 1
- Min value : 82 %
5. If the lighting loads never switch off (minimal lighting)
• Reduce and adjust the value of the “Lux Off level” parameter” in steps
of 10 or 20
Example:
- Lux level for regulation = 150
- Lux On Level = 145
- Lux Off Level = 215
- Lux Off Time = 1
- Min value : 82 %
6. If the light level is too high
- Reduce and adjust the value of the “Lux level for regulation” parameter.
- Adjust the value of the following parameters:
• Lux On level = Lux level for regulation - 5
• Lux Off level = Lux level for regulation x 1.5
Example:
- Lux level for regulation = 130
- Lux On level = 125
- Lux Off level = 195
- Lux Off time = 1
- Min value : 82 %
9. PERFORMANCE
Detection area
NOTE: The illustration shows an average of the walk across and walk
towards figures below.
Walk across
Walk towards
Height
Diameter
7 m
16 m
2.8 m
9 m
Height
Diameter
7 m
10 m
2.8 m
5 m
10. CARE
Keep the lens clean, use a cloth to clean the surface.
Do not use acetone, tar-removing cleaning agents or trichloroethylene.
CAUTION: Always test before using other special cleaning
products.
11. STANDARDS
Directive: CE
Installation standards: NFC 15-100
Product standards: NF EN 60730-1
Environmental standards:
- European Directive 2012/19/EU: WEEE (Waste Electrical and Electronic
Equipment)
- European Directive 2011/65/EU and 2015/863. RoHS (Restriction of
Hazardous Substances)
- Decrees and/or regulations: Public buildings, workplace buildings,high-
rise buildings
Conformity:
- EMC-2014/30/EU
- LVD-2014/35/EU
