6
Anti-theft device
The built-in anti-theft device prevents the detector being stolen (in an
apartment block for example).
After breaking off both lugs (see location below), the detector can be
locked in position.
If necessary, you can simply use a small screwdriver to turn the mechanical
locking lever through the opening in the base (see illustration below).
Opening
Locking lug
Mechanical locking lever
Commissioning the smoke alarm battery
1 - Remove the tab by pulling it towards you. After 20 s, the self-contained
smoke detector/alarm will be operational (see below on left)
2 - Store the tab in the special slot (see below on right)
11
EN 14604:200
5
CPD xxx
xxx
DAAF
ATTEN
TION
11
Dispositif d’a
larme de fumée
EN 14604:20
05
CPD xxx xxx
DAAF
FINSECUR
vous recom
mande de
remplacer
ce disp osit
if en :
N/S:
ATTENTION
Pile non remp
laçable
Voir manuel
d'instruction
When the detector reaches its end of life, you can disconnect the battery
using the tab to stop the fault audible signal and prevent any electrical
hazards during recycling (see Decommissioning the self-contained smoke
detector/alarm paragraph).
Positioning the detector
1 - Place the detector on its base.
2 - Turn clockwise until it locks.
If the test button is not facing the entrance to the room, you can unlock
it (turn anti-clockwise) to give the detector a half-turn.
3 - Press the Test button to check it is working.
