Storage
Do Not move
or store the ‘Garden Cube’ until the fire is completely out.
1. Once the fire is out, coals and ash are cold and
‘garden Cube’ is cool to touch, open door and lift out burner rack, then brush all ash and coals into pedestal, replace
burner rack and close door. Leave for a short period to allow ash to settle in ash pan. Then remove ashpan and dispose of ashes in a suitable manor, and re-fit ash
pan.
2.
Store ‘Garden Cube’ assembled in a suitable location away from children and pets.
Note: if you do not use a cove
r, store the ‘Garden Cube’ in a dry location to maximize product life.
GUARANTEE
CONDITIONS OF WARRANTY
If this appliance should prove to be defective due to faulty design, materials or workmanship within 12 months of purchase, the product will be repaired free, subject to the
following conditions.
1. The ‘Garden Cube’ shall have been purchased and used solely within the UK for domestic purposes and in accordance with the Users Operating instructions.
2. It is the
purchaser’s responsibility to prove that the unit is under guarantee, e.g. receipt of purchase.
3. On discovery of a fault, the purchaser should contact the dealer from whom the product was purchased in order to ascertain whether they or a service centre will carry out
the repair. If problems are encountered the purchaser may contact the service centre shown with this product. All transportat
ion will be at the purchaser’s expense and risk.
4. All guarantees will be invalidated if unauthorised repairs or
modifications are made to the ‘Garden Cube’, or in case of accident, misuse, or damage caused by improper
installation, or to damage occurring during transit to or from the repairer and altered or missing serial numbers.
5. Any parts, which have been replaced under this guarantee, shall become our property.
6. The company shall not be liable for any consequential loss or damage whatsoever, arising from or in connection with this ‘Garden Cube’.
8. ‘No fault found’, service calls and installation errors are not covered under the Manufacturers guarantee and will result in a charge being made for the call out by our
appointed service engineer.
9. This guarantee is in addition to and does not affect the purchaser’s statutory rights of Consumers.
10. The company will arrange call-out requests within a mutually agreed time frame. If the companies appointed engineer cannot gain access or receives no answer, a call-out
charge will be incurred.
11. The company reserve the right to alter, change and amend or cancel any aspect of these terms & conditions in whole or part without prior notice.
Glass Removal
To remove Glass open door and slacken glass retention screws,
then slide glass panels out in directions shown. Door can be
removed whilst holding the door in the closed position, remove the
screw on top front left corner, once screw is removed tilt door
forward to clear top panel and lift off. To replace reverse the
procedure, ensure that the glass is kept square to the frame when
sliding the glass in to avoid damage to the glass. Do not over
tighten Glass retention screws as this may cause glass to break.
