COMMISSIONING
9
1. Remove the burner assembly (2 x wing nuts) and
chosen gas inlet plate in the base or the rear. (Fig. 13).
2. Relocate the burner assembly and mark/cut gas pipe
to length, then secure burner assembly with the M5
machine screws and connect the gas pipe and purge.
(Fig. 13).
3. Connect manometer to pressure test point on the
brass Pressure Test elbow and ignite the burner to
check working pressure and gas rate see (page 11).
Note: the gas rate is factory set and is not adjustable
without specialised Legend equipment.
4. Refit heat shield, gas connection cover panel must
be always fitted (Fig. 14).
M5 Machine Screws
Burner Assembly
Inlet Pressure
Test Point
Fig. 13
Fig. 14
Gas Connection
Cover Panel
Lower Controls
Heat Shield
