Operating Instructions
Checking for leaks
*WARNING: Before using this outdoor fireplace, make sure you have read , understand and
are following all information provided in the “Warnings” section. Failure to follow those
instructions can cause death, serious injury or property damage.
Burner connections
1. Make sure the regulator hose and valve connections are securely fastened to the burner
and the tank.
2. Visually check the connection between the burner/venturi tube and orifice.
3. Make sure the burner/venturi tube fits over the orifice.
WARNING: Failure to inspect this connection or follow these instruction which can
cause death, serious bodily injury or damage to property.
4. Please refer to diagrams for proper installation .
Tank/Gas line connection
1. Make 2-3 oz. of leak detection solution by mixing one part liquid dishwashing soap with
three parts water.
2. Make sure the control knob is in the "OFF” position.
3. Connect LP gas tank per “Installing LP Gas tank” section.
4. Turn LP gas tank valve to “ON”
5. Spoon several drops of solution or use a spray bottle at all connected locations .
a. If any bubbles appear, turn LP gas tank valve “OFF”, reconnect and retest.
b. If you continue to see bubbles after several attempts, turn LP gas tank valve “OFF”
and disconnect LP Gas tank, per “Disconnecting LP gas tank” section. Contact
customer service for assistance 1-800-379-2185.
c. If no bubbles appear after one minute, turn LP gas tank valve “OFF”, wipe away
solution and proceed.
Lighting:
1) Make sure the control knob is in the “OFF” position (Figure A).
2) Fully open LP cylinder valve.
Note: For initial start or after any cylinder change, hold Control Knob IN for 2 minutes to purge
proceeding.
3) Push in gas control knob, turn counterclockwise to “LOW” (Figure B), and press the
gnitor button to light the fire
pit. If needed, keep the control knob depressed and continue pressing the
Ignitor
button until the fire pit lights (you should hear a clicking sound).
4) After the fire pit lights, release control knob. To increase the flame, turn the control knob
counterclockwise to "HIGH" (Figure C). To decrease the flame, turn the control knob
clockwise to “LOW”.
Note
:
If burner fails to remain lit, all valves should be closed and a waiting period of at least
attempting to light.
5 minutes should pass before
OFF
PU
SH
TO
T
U
R
E
N
LOW
HIGH
C
e
r
u
g
i
F
B
e
r
u
g
i
F
A
e
r
u
g
i
F
OFF
P
U
S
H
TO
TU
RE
N
IGNITOR
IGNITOR
HIGH
OFF
IGNITOR
HIGH
LOW
LOW
P
U
S
H
T
O
T
U
R
E
N
I
air from gas lines before
Page 19 of 26
BLACK
BLACK
