3
1
2
78mm~103mm
Water outlet
Water outlet
Hot water
supply pipe
Cold water
supply pipe
Stopper A
(marked #049000)
Stopper B
(marked #049001)
Washer C
4
Dimple on valve stem
Notch
Stopper A
(marked #049000)
6
5
REMOVE CAP ONLY, KEEP THE REST OF
THE MUD GUARD AS IT IS NEEDED TO
HOLD THE TRIM FIXING SCREWS.
4
Steps 1-6
Installation Procedure
Lefroy Brooks always recommends that plumbing products be installed by a licensed professional.
Shut off main water supply before installation.
1
While placing the valve into wall, make sure that the distance between the wall surface and the
back of the valve is between 78~103mm as the figure indicates.
2
Connect the valve with water pipes.
3
Throw away the protective cap only when the building construction is completed and you are
ready to fit the trim kit in.
REMOVE CAP ONLY, KEEP THE REST OF THE MUD GUARD AS IT IS NEEDED TO HOLD THE TRIM
FIXING SCREWS.
4
Temperature Limiting Device: Remove washer C, then take off stopper A & B.
5
Turn the valve stem so that the round dimple on the stem is at the top side.
6
Install stopper A onto valve stem. Notch on stopper A should point upward.
