LED
Sensor power on procedure
Detection range adjustment procedure
4
Please read this chapter carefully and make sure you understand before you start the installation.
1. The optimum detection range has been set up already. In general circumstances, you do not need
to set or adjust it again.
2. Before connecting the power supply to start the sensor, you must keep the front & surrounding
area of the faucet clear, to make sure there is no unexpected detection.
3. As soon as you are ready to connect the power supply (Installation step-7), please make sure the
following steps are implemented by the sensor. Then afterwards you can feel confident to use the
sensor smoothly and normally
6 seconds after power supply is connected
---> LED light on for another 6 seconds
---> LED light off ---> normal function.
Please read this chapter carefully and make sure you understand before you start the installation.
1. Firstly, implement the Sensor Power On Procedure step 1~ 2.
2. As soon as you are ready to connect power supply (Installation step-7), please make sure the
following steps to manually set up Detection Range are implemented. Then you can feel free to
use sensor smoothly and normally.
Within 6 seconds after power supply is connected, place hand firmly in the desired location in
front of the sensor until the LED light comes on
--> LED light flashes 3 times
--> LED light off
--> normal function.
4. In case you need to adjust the detection range for any particular circumstance, please refer to the
next chapter below:
