ATEM2LENS Users guide
Page 1
ATEM
2
LENS
USERS GUIDE
v2.2
(this users guide is a
‘work in progress’
and will be updated on a regular basis. Please refer to the version number)
***** WARNING *****
Remember to disconnect the 12 volt power when connecting anything to the FujiCanon
controller. While in most cases it will work there is the possibility it may permanently
disable the controller electronics. There is no problem connecting the extended tally light.
Connections
INTERFACE END
RESET
- Resets the controller to startup state
SETUP
– Single press enters individual setup modes
ZOOM/IRIS DEMAND
- for the ZOOM/IRIS control
FINE ZOOM NULL
– for adjusting any zoom creep
FOCUS DEMAND
– for the FOCUS control
FOCUS SERVO
– for the FOCUS SERVO UNIT. Note the
Orange marker to indicate the orientation of the plug.
LENS POWER & IRIS
– Connection from the lens
LENS ZOOM
– Connection to the lens
INPUT/OUTPUT END
EXTENDED TALLY LIGHT
– Allows connection of a tri-
coloured LED to
extend
PROGRAM/PREVIEW tally.
(this is a 4 pin 3.5mm jack – tip =
common
,
ring 1 =
GREEN
, ring 2 =
RED
, sleeve =
BLUE
)
RETURN SDI IN
– SDI IN from the ATEM
RETURN SDI OUT
- SDI OUT to the camera
12v POWER IN
– Powers the controller and the lens
USB CONFIG/UPDATE PORT
– Use this to configure the
lens controller and to provide software updates. It also
is used for status information including Serial Number,
Software Version and override status.