GuestCall Troubleshooting
Charge light will not come on
a. Make sure there is power to the outlet
b. Try changing the position of the coasters on the stack. Make sure they are seated properly with the numbers
facing front.
c. Using a damp rag, clean metal contacts on coaster that will not light
d. Check all connections on charger bases. If only one stack of coasters will not light on the charger,
There is probably a bad connection. Move wires and be sure they are all plugged into back of black coaster
charger.
If you try all this and the coaster charging light will not come on you most likely have a blown power supply.
Transmitter will not display anything
a. Make sure there is power to the outlet
b. Check all connections.
If you try all this and the transmitter still wont power up your power supply may be bad. If display is still blank, call NTN.
No range on coaster pagers
a. Be sure transmitter is not near any large metal objects, fire walls, etc.
b. Be sure antenna is connected properly and not broken.
Coasters are not paging or paging in a manner you did not program
Review Coaster modes and enter the code for the mode you would like. It probably has changed.
Coasters are not answering the page or acting strange
Make sure the Coaster has a full charge.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS :
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
*Remember that the capability of your system will be affected by: Foil backed wallboard, Metal mesh, wire reinforced glass,
metal sheeting, large mirrors, suspended ceilings, lift shafts etc. These can all
reflect and thereby reduce the signaling capability of the transmitter. A little forethought prior to installation, coupled with a
few tests, can normally avoid most of these problems.
1. Read through the instruction manual. Answers to most questions can be found there. A trouble shooting
section further assists you in diagnosing the problem.
2. statement required by 15.21 :
The users manual or instruction manual for an intentional or unintentional radiator shall caution the user that
changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
Warning: Changes or modifications made to this equipment not expressly approved by
COMPANY
may void the
FCC authorization to operate this equipment.
3.
CAUTION
:
Never use any cleaner other than alcohol for the maintenance of this equipment. Organic solvent
such as benzene, toluene or acetone may spoil the plastic parts of this equipment
.
4.RF Radiation Exposure
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment must be installed and operated with a
minimum distance of 20 centimeters between the radiator and your body.
Содержание Guestcall QBTLTK-P1200
Страница 11: ......