201606
Version
LED WALL PACK INSTALLATION INSTRUCTIONS
Ambient temperature for lighting fixture: -30
℃
~50
℃
SAFETY INSTRUCTION
Read instructions carefully before attempting to install fixture. Retain instruction for future reference.
All wiring should be performed by a qualified electrician
.
Disconnect power before installing or servicing. This fixture must be wired in accordance with the National
Electrical Code and applicable local codes and ordinances.
Proper grounding is required to ensure personal safety.
This fixture is for outdoor use and should not be used in areas with limited ventilation or high ambient temperatures.
Caution
– Risk of Fire
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
IMPORTANT:
In order to comply with established electrical code, the installer
must seal
the area
around the mounting plate and the wall, with silicone sealant to provide a watertight seal.
MOUNTING
-
The back plate has a cast-in drill and knock-out template to match any standard recessed
junction box, three 5/16” knockouts for mounting holes B and four 1/2” NPS tapped holes A for surface conduit,
photo control.
A - 1/ 2” NPS tapped holes. C-Holes for # 10 screw
B - 5/16” dia. knockouts
LOCATION
: Fixture should be located on wall at least 18’’ below any overhang or other structural detail.
Fixture should not be recessed. Fixture must be positioned with lamp in horizontal position
INSTALLATION
-
CUT OFF SHIELD
(OPTIONAL)
C
1
2
4
5
3
A
A
A
B
B
B
LOD-WP-40WSADXXK-HL
LOD-WP-60WSADXXK-HL
