Phone:
(844) LEDONE6 |
Fax:
1-510-217-9461 |
Web:
www.ledonecorp.com
`
INSTALLATION:
1.
Separate the mounting bracket from the fixture.
2.
Line up the mounting bracket and EVA gasket in desired location and mount securely. (EVA gaskets will provide
weather-tight seal).
3.
Bring the fixture up to the mounting bracket and hook the bottom of the fixture onto the keyhole slot at a 45° angle
on the mounting bracket for hands-free wiring.
4.
Complete the wiring to the power source and ground. (Fig. 2 & 3)
5.
Bring the fixture onto an upright position and make sure the clips on the fixture slide into the keyhole on the
mounting bracket.
6.
Slide down the fixture, tighten the set screw and make sure the fixture is securely mounted on the bracket.
PHOTOCELL INSTALLATION: (If comes with photocell)
The wall pack comes with a photocell preinstalled. To activate the photocell, remove the plastic cap. If you do not wish to use the photocell, keep the
plastic cap on.
Photocell may be installed in the field. Apply weatherproof silicone sealant to all plugs around the photocell and unused conduit entries.
1.
Remove close-up plug on top of the wall mounting box.
2.
Install the photocell and wire as per diagram Fig. 1.
3.
Use photocell rated for your supply voltage.
ON-OFF WIRING:
Universal voltage driver permits operation at 120V through 277V, 50/60Hz. Units ordered with (/480V) suffix are 480V, 60Hz. For non-
dimming, follow the wiring directions in Fig 2.
1.
Connect the BLACK fixture lead to the (+) LINE supply lead.
2.
Connect the WHITE fixture lead to the (-) COMMON supply lead.
3.
Connect the GROUND wire from fixture to supply ground.
0-10V DIMMABLE WIRING:
Universal voltage driver permits operation at 120V through 277V, 50/60Hz. For 0-10V dimming, follow the wiring instructions in Fig 3.
1.
Connect the BLACK fixture lead to the (+) LINE supply lead.
2.
Connect the WHITE fixture lead to the (-) COMMON supply lead.
3.
Connect the GROUND wire from fixture to supply ground. DO NOT connect the GROUND of the dimming fixture to
the output.
4.
Connect the WHITE fixture lead to the (V+) DIM lead.
5.
Connect the BLACK fixture lead to the (V-) DIM lead.
6.
The driver comes with dimmable leads. If it is unused, make sure the leads are properly capped (if applicable).
