Phone:
(844) LEDONE6 |
Fax:
1-510-217-9461 |
Web:
www.ledonecorp.com
`
LOC-WP Series Installation Guide
Cut off shield
(optional)
Ambient temperature for lighting fixture: -40°C + 40°C
SAFETY INSTRUCTIONS: Read instructions carefully before attempting to install fixture.
•
All wiring should be performed by a qualified electrician.
•
Disconnect power before installing or servicing. This fixture must be wired in accordance with the National Electrical
Code and applicable local codes and ordinances.
•
Proper grounding is required to ensure personal safety.
•
This fixture is for outdoor use and should not be used in areas with limited ventilation or high ambient temperatures.
CAUTION: Risk of fire
•
WARNING:
Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
•
IMPORTANT:
In order to comply with established electrical code, the installer
must
seal the area around the
mounting plate and the wall with silicone sealant to provide a watertight deal.
MOUNTING:
The back plate has a cast-in drill and knock-out template to
match any standard recessed junction box, three 5/16” knockouts
for mounting holes B and four ½” NPS tapped holes A for surface conduit, photo
cell.
LOCATION:
Fixture should be located on the wall at least 18” below any overhang or other structural det
ail. Fixture should not be
recessed. Fixture must be positioned with lamp in horizontal position.
CLEANING & MAINTENANCE:
CAUTION: Be sure the fixture temperature is cool enough to touch. Do NOT clean or maintain while the fixture is energized.
1.
Clean glass lens with non-abrasive glass cleaning solution.
2.
Do NOT open fixture to clean the LED. Do NOT touch the LED.
Note: These instructions do not cover all details or variation in equipment, nor do they provide for every possible situation during
installation, operation or maintenance.
A:
1/2” NPS tapped holes 5/6” dia. Knockouts
C: Holes for #12 screw B
