www.prolight.co.uk
VersiLED 6 DMX Controller
User Manual
4
Initial setup:
Connect the supplied mains power adaptor to the DC power input on the controller and then to a
suitable mains voltage supply (100-240VAC~50/60Hz).
The controller can be used to control 3, 4, 5 or 6 colour LED products each with or without a
dimmer channel.
The controller is based around LTP (Last Takes Precedence) across its control surface, this means the
last command executed on the controller will override the previous command. Because of this, the
controller is easy to use for those who carry little knowledge of DMX controllers.
DMX channel assignment:
The controller has preset DMX start addresses for each of the four fixtures. Please set your fixture to the
following DMX addresses.
Please note: If two or more fixtures are set to the same DMX address they will receive the same
DMX commands.
Master dimmer:
The controller also has an additional Master Dimmer function. While holding down the Blackout
button, use the strobe/dimmer fader to adjust the overall master intensity. This function will operate for
all fixtures regardless of fixture selection. The master dimmer function will override all outputs including
sound and auto modes. If you have used the master dimmer to dim your fixture(s) to zero you will have
to dim them back up in order to use manual dimming/colour mixing again.
01) RGBWAUV/D channel faders:
The RGBWAUV/D faders are used to create a manual colour mix. First select the fixture groups
as required from the four fixture groups and then use the faders to adjust the colour and intensity
as required.
02) Fixture/group buttons and LED indicators:
The fixture/group buttons are used to select or deselect fixtures. Next to each button is an LED
indicator, this will illuminate when the fixtures are selected.
Operating instructions
Fixture Number Group
DMX Start Address
1
001
2
011
3
021
4
0 31
