Ledj Omni Tri-9, Руководство пользователя, Страница: 5 / 8

1, Static colour mode
Mode button - Press the “MODE” button under the LED display, to show “C000” , then press the
“ENTER” button to choose one of the static colours using the “UP” and “DOWN” buttons.
The “C1” represents Red, “C2” = Green, “C3” = Blue and “CF” = strobe.
The two digits after it are the brightness 00 to 99 or in “CF” they are the strobe speed.
Examples: If you set C1, C2 and C3 to zero, the Omni tri will have no LEDs on (blackout).
If you set C1 to 99 and C2 and C3 to zero, the Omni tri will be 100% Red.
2, Colour change mode
Mode button - Press the MODE button until the LED display shows “J000” , then press the
“ENTER” button to choose one of the colour changing modes using the “UP” and “DOWN” buttons.
1, “J300” = RGB, 2, “J700” = 7 colour, 3, “JF00” = Strobe,
Now press the “ENTER” button again and you can then select the colour change speed using the
“UP” and “DOWN” buttons.
The speed settings are from 00-99 (00 = slow, 99 = fast)
The strobe speed settings are from 00-99 (00 = slow, 99 = fast)
3, Colour fade mode
Mode button - Press the MODE button until the LED display shows “F000” , then press the
“ENTER” button to choose one of the colour fading modes using the “UP” and “DOWN” buttons.
1, “F300” = RGB, 2, “F700” = 7 colour, 3, “FF00” = Strobe,
Now press the “ENTER” button again and you can then select the colour fade speed using the
“UP” and “DOWN” buttons.
The speed settings are from 00-99 (00 = slow, 99 = fast)
The strobe speed settings are from 00-99 (00 = slow, 99 = fast)
4, Sound active mode
Mode button - Press the MODE button until the LED display shows “S000” , then press the
“ENTER” button to choose one of the sound active modes using the “UP” and “DOWN” buttons.
1, “S300” = RGB, 2, “S700” = 7 colour,
5). Slave mode
Link the units together using a 3-pin DMX cable, then press the MODE button to select one of the
above modes. On the Slave units press the mode button until the LED display shows “SLAV”. The
Slave units will then follow in sequence with the Master unit.
6). DMX Addressing mode
To access the DMX address mode, press the
MODE
button until the LED display shows
“A000”,
then press the “ENTER” button and set the first digit in the DMX address using the “UP” and
“DOWN” buttons. Now repeat this step to set the second and third digits for the desired DMX
address setting. Once you have set the DMX address, cycle through the other operating modes back
to the DMX mode. The unit will now remember your DMX address setting.
Follow the DMX channel assignment and function table overleaf.
Note: Always press the “ENTER” button a fourth time to confirm the setting.
LEDJ Omni Tri-9 Operation