www.prolight.co.uk
Vector Beam Quad
User Manual
8
Operating instructions
LED:
Press
“ENTER”
to go into the LED settings. Within this the user can either choose
“e-Auto”
or
“e-Manul”
.
“e-Auto”
- press the
“ENTER”
button for a menu to adjust the speed and frequency.
“SPEED”
- press the
“ENTER”
button to adjust the speed between
“1-20”
(1 being slowest,
20 being fastest).
“FREQ”
- press the
“ENTER”
button to adjust the flash speed from
“00-20Hz”
(00 being lowest,
20 being highest).
“e-Manul”
- press the
“ENTER”
button for a menu to choose the colour you require:
Red/Green/Blue/White/Yellow/Cyan/Purple/Light Red/Light Green/Light Blue/All on/Black.
BAR:
Press
“ENTER”
to go into the BAR settings. Within this the user can either choose
“m-Auto”
or
“m-Manul”
.
“m-Auto”
- press the
“ENTER”
button to adjust the speed between
“16”
(1 being slowest,
16 being fastest).
“m-Manul”
- press the
“ENTER”
button to adjust the position of the left and right bar.
“L-BAR”
- press the
“ENTER”
button to adjust the left bar between
“0-180°”
.
“R-BAR”
- press the
“ENTER”
button to adjust the left bar between
“0-180°”
.
Sound mode:
To access sound mode, press the
“MENU”
button on the rear of the unit to show
“SOUND”
on the
LCD display. Now press the
“ENTER”
button and use the
“UP”
and
“DOWN”
buttons to select the
sensitivity between
“01-31”
(01 being lowest, 31 being highest).
Slave mode:
To access sound mode, press the
“MENU”
button on the rear of the unit to show
“SLAVE”
on the
LCD display.
Settings:
To access the fixtures settings, press the
“MENU”
button on the rear of the unit to show
“SETTINGS”
on
the LCD display
.
Now press the
“ENTER”
button and use the
“UP”
and
“DOWN”
buttons to adjust
each setting. These are as follows:
“BL TIME”
- press the
“ENTER”
button to adjust the LCD backlight auto switch-off time from
“ON”
to
“30s”
.
“ADJUST”
- press the
“ENTER”
button to manually adjust the electronic motor position of the left and
right bar from
“-999 - +999”
.
“RESET”
- press the
“ENTER”
button to restore the factory settings. You can also do this by holding
“MENU”
and
“ENTER”
when the unit is being powered up.
“MOTO”
- press the
“ENTER”
button and the unit will display a reset code.
“POWER”
- press the
“ENTER”
button and the unit will display the fixtures voltage.
“ABOUT”
- press the
“ENTER”
button and the unit will display the model.
