Operation:
There are 5 different operation modes to choose from:
1) Static colour mode
2) Colour change mode 3) Colour fade mode
4) Master/slave
5) DMX mode
1, Static colour mode
Mode button -
Press the
“MODE”
button under the LED display, to show
“C000”
, then press the
“ENTER”
button to choose one of the static colours using the
“UP”
and
“DOWN”
buttons.
The
“C1”
represents Red,
“C2”
= Green,
“C3” =
Blue and
“CF”
= strobe.
The two digits after it are the brightness 00 to 99 or in
“CF”
they are the strobe speed.
Examples: If you set C1, C2 and C3 to zero, the Outdoor Tri Par will have no LEDs on (blackout).
If you set C1 to 99 and C2 and C3 to zero, the Tri Par will be 100% Red.
NOTE: For static selection of Red, Green, and Blue, ensure that the unwanted
colours are set to “00”.
2, Colour change mode
Mode button -
Press the “
MODE’
button until the LED display shows
“J000”
, then press the
“ENTER”
button to choose one of the colour changing modes using the
“UP”
and
“DOWN”
buttons.
The colour change programmes are as follows:
1, “J300” = RGB, 2, “J700” = 7 colour,
3, “JF00” = Strobe,
Now press the
“ENTER”
button again and you can then select the colour change speed using the
“UP”
and
“DOWN”
buttons.
The speed settings are from 00-99 (00 = slow, 99 = fast)
3, Colour fade mode
Mode button -
Press the
MODE
button until the LED display shows
“F000”
, then press the
“ENTER”
button to choose one of the colour fading modes using the
“UP”
and
“DOWN”
buttons.
The colour fade programmes are as follows:
1, “F300” = RGB, 2, “F700” = 7 colour, 3, “FF00” = Strobe,
Now press the
“ENTER”
button again and you can then select the colour fade speed using the
“UP”
and
“DOWN”
buttons.
The speed settings are from 00-99 (00 = slow, 99 = fast)
4. Master/slave mode
Link the units together using a 3-pin DMX cable, then press the “
MODE”
button to select one of the
above modes. On the Slave units press the mode button until the LED display shows
“SLAV”.
The
Slave units will then follow in sequence with the Master unit.
Note: To confirm the setting in any of the above mode always press the “ENTER” button a
final time so that the LED display stops flashing.
Outdoor Tri Par
Operation