Master/Slave
The Master/Slave mode will allow you to link up as many units as you want in a daisy chain
fashion. In this mode, the first unit in the daisy chain will control the following units.
1) Connect all units in a daisy chain as described in the section following.
2) For master unit in Auto mode: Set dip switch
8
to
ON
and all others to
OFF
3) For master unit in Sound Activation mode: Set dip switch
8+9
to
ON
and all others to
OFF
4) For Slave mode: set dip switches
10+1
to
ON
and all others to
OFF
Stand-Alone Mode
• You can run the fixtures in an automatic stand-alone mode by simply setting all fixtures
to run as master units. (set dip switch #8 to on and all others off).
Sound Activation
The Colour Burst has a built-in microphone which enables it to operate in Sound to Light mode.
Set the sensitivity control to the desired level, and the Colour Burst will change colour to the beat
of the music. Set dip switch
8+9
to
ON
to activate Sound Mode.
Daisy Chain Connection
1) Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin
connector of the first fixture
2) Connect the end of the cable coming from the first fixture which will have a (female) 3 pin
connector to the input connector of the next fixture consisting of a (male) 3 pin connector.
Proceed to connect from the output as stated above to the input of the following fixture
and so on.
on
DMX512
IN
OUT
on
DMX512
IN
OUT
MASTER SETTING
SLAVE SETTING
on
Dip switches 1-8
(programmes)
POWER
IN
AC
LINE
INPUT FROM DMX CONTROLLER
(OPTIONAL)
Use 3 pin XLR DMX cable
Continue
FUSE
1A
POWER
IN
FUSE
1A
POWER
IN
FUSE
1A
POWER
IN
FUSE
1A
ON
ON
ON
ON
IN
OUT
IN
OUT
IN
OUT
IN
OUT
