Version 05112017
3
Using an RGB Hardwire Connector, wire the stripped ends of the connector
to the OUTPUT terminals of the RGB DMX Decoder. Use the ”V+” terminal
for the gray (or black) wire, the “R” terminal for the red wire, the “G” terminal
for the green wire, and the “B” terminal for the blue wire. Screw down each
terminal with a mini flathead screwdriver to secure the wire.
Note: The “W” terminals will not be used.
Tip: In the event you need to wire more than one RGB Hardwire Connector to the
RGB DMX Decoder, you may use the additional terminal of each channel (V+, R, G,
B) for any additonal RGB tape light runs . You may wire multiple runs of RGB tape
light to each terminal; however, ensure the terminals allow enough space for each
wire.
Connect the CAT-5 cable from your RGB DMX Controller to
the INPUT Ethernet port.
If wiring additional RGB DMX Decoders, connect a CAT-5
cable to the OUTPUT Ethernet port of the RGB DMX Decoder
you just installed. Connect the same CAT-5 cable to the INPUT
Ethernet port of your next RGB DMX Decoder. Repeat this
process for any additional RGB DMX Decoders you install.
To RGB DMX Controller
1
2
3
*Items sold separately.
**Only needed if installing three or more RGB DMX Decoders.
RGB DMX Terminators are sold separately.
Parts Needed
Tools Needed
x1 or More
RGB DMX Decoder(s)
x1
RGB DMX Controller*
x1 or More
CAT-5 Cable(s)*
x1 or More
RGB Hardwire Connector(s)*
x1 or More
24V DC Electronic Driver(s)*
x1 or More Run(s)
of RGB Tape Light*
x2 or More
Wire Nuts*
x1
RGB DMX Terminator**
x1
Mini Flathead Screwdriver
x1
Wire Strippers
IMPORTANT! ENSURE ALL AC POWER HAS BEEN
SHUT OFF BEFORE PERFORMING THIS INSTALLATION!
Installing the RGB DMX Decoder
Additional Terminal
Additional Terminal
Additional Terminal
Additional Terminal
Not Used
Not Used
