3
11.
Connect the yellow wire from the output of the Golf
Cart Battery Voltage Reducer to the positive wire of
the lighting accessory that you are installing to the golf
cart using a crimp on butt connector or a similar
connector. If possible, soldering the wires is
recommended to ensure a secure connection.
12.
Connect the black wire from the output of the Golf
Cart Battery Voltage Reducer to the ground wire of the
lighting accessory that you are installing to the golf
cart using a crimp on butt connector or similar
connector. If possible, soldering the wires is
recommended to ensure a secure connection.
13.
Reconnect the main negative terminal of the golf cart’s
battery and switch your cart back to RUN mode (if available).
Connecting Power to Gas Engine Carts:
1.
Connect the red wire to a 12 volt source. If you are unsure, verify voltage with a multimeter before connecting the kit to
the golf cart. Note: If you need to extend the power wires, be sure to use a 16 or 18 gauge automotive grade wire. If you
are running the power wire to the battery and must go through metal, use an existing grommet or drill a hole and add a
new grommet, which is available at any auto parts store. Be sure to reinstall the fuse within 6 inches of the power source.
If you connect the power wire to a switched 12 volt source, then it will not remember the previous color and pattern it
was last on.
2.
Connect the black wire to a good ground source, grounding block, or directly to the negative terminal of the battery.
Testing Operation of the Kit:
1.
Lower the golf cart if it was raised and test your new LEDGlow Million Color LED Golf Cart Underbody Kit. Cycle through
the colors and modes to ensure full functionality.
2.
Turn the steering wheel as far as it can go in both directions to ensure that there will be no tubes and/or wires coming
into contact with the tires.
If a tube or wire is damaged by the tire, the warranty will be voided.
Control Box & Wireless Remote Functions:
Power Button
On/Off
Mode Button
Solid Illumination
,
7 Running Modes
,
Pulse Mode
,
3 Scan Modes
,
3 Strobe Modes
,
3 Fade Modes
,
S.O.S Mode
,
4 Music Modes
,
Demo Mode
Color Button
Red
, Hot Pink, Pink, Purple, Orange, Yellow, Green, Teal, Blue, White, Color Cycle, Color Fade
Speed Button
5 Speed Levels
Enable Auto On/Off Function:
Turn the kit off. Press and hold down
Mode
and
Color
buttons on the control box. After
the
teal
color lights up, turn on the kit and test for functionality.
Disable Auto On/Off Function:
Turn the kit off. Press and hold down
Mode
and
Speed
buttons on the control box. After
the
Orange
color lights up, turn on the kit and test for functionality.
Adding or Replacing a Wireless Remote:
1.
Your kit is already pre-programmed for the included wireless remotes. This setup is only needed when replacing an existing
remote or by adding additional wireless remotes to your system. You can program up to 2 wireless remotes to 1 control box.
2.
In order to program the remote to the control box, you must turn the kit off.
Press and hold the “Mode” button on the control box and any button on the wireless remote simultaneously for 5-7
seconds to turn the kit off. The LEDs on the kit will illuminate green if successful. Test the operation with the remote.
For accessories, replacement parts and/or technical support, please visit
(Rev. 11-17)
