Cutting Instructions
03
Correct
Place the light horizontally when cutting it, and check out the
marker line at PCB surface, use only factory-recommended
The minimum cutting length is 10cm (Fig. 3.2), and can be cut
internal circuit board.
Fig. 3.1
Cutting Nippers
Incorrect
cutting Nippers
to cut (Fig. 3.1), if use other cutter caused the
Fig. 3.2
Mi
n. C
utt
ing L
en
gth
: 10
cm
Marker Line
Cutting Nippers
Marker Line
Fig. 3.4
Cutting Nippers
Marker Line
Wave Cut incorrect
R>90° Cut incorrect
R<90° Cut incorrect
cut from the side is incorrect
Not cut at the marking line, incorrect
Fig. 3.3
Correct
—
Cut at the marking line
into varous length (e.g. 30cm, 50cm, ... 5000cm Maxi.).
Do not place the light on its side to cut
,
and
doing
so
will result
in damaging the internal circuit board (Fig. 3.3), and R<90 or
°
R>90
internal circuit board
°
or wave cutting will damage the
.
Cutting must be done at the marker line, and pls do not cut
at other place (Fig. 3.4), and
will result in damaging
doing
so
the internal circuit board.