4/4
Note: Diagram below shows 2 wire, but RGBW strip will have 5 wires
Apply 1 ½” long electrical heat shrink over all connection points. Secure connection wire with wire clamp.
IMPORTANT !
Wrong!
4"
(100mm)
On widest one flat plane (only)
Do not bend sideways.
Flexible on one axis
maximum band radius 4”
TROUBLESHOOTING
Ÿ
Make sure your power supply is turned on and has the correct voltage.
Tape light strip does not light
Ÿ
Have a electrician check all connections and any switch or dimmer connections from the power supply to the LED Light Strips.
Ÿ
Confirm you have the correct polarity (+ to +, G to G, R to R, B to B and W to W) throughout the run of LED Lighting.
Ÿ
Consider testing with a multimeter to ensure light strip is receiving 24V power.
Ÿ
This is the result of voltage drop. Decrease the length of the 24V power feed or use thicker power feed wires between the 24V power supply
and the lighting strips.
LEDs farthest from the power supply are noticeably dimmer
LED Flex Strip lights blink on, then go off
Ÿ
The power supply is not adequate for the length of LED Light Strips you are powering. Install a adequate Class 2 power supply.
MAXIMUM FLEXSTRIP LENGTH SUPPORTED BY LED WORLD’s CLASS 2 POWER SUPPLY
NOTE:
It is recommended to mount our RGBCCT LED flexstrip with Aluminum profiles, as Aluminum profiles acts as a heat sink.
NOTE: This model of RGBCCT LED Strip has pigtail connectors on both ends. Use only one connector end and remove the additional end
connector wire if entire roll is used before attaching to power supply. Otherwise there is possibility of short circuit that may create a serious
hazard and damage. This additional wire at the end of the roll is provided to make it easier to connect if the strip is cut. Do not attach an
additional roll to end wire. The roll size (5m/16.4ft) is the maximum length that can be attached to a regulated class 2 power source.
IMPORTANT !
+
-
-
-
+
-
Cut Mark
Pigtail Connector
Pigtail Connector
IMPORTANT INSTRUCTIONS
1-800-387-4081
ledworldlighting.com ledworld.ca
|
Power Supply
Max Feet of LED Flexstrips
Power Supply
Max Feet of LED Flexstrips
21.4 Feet (Continuous 77 Watts)
MD-024-096VTDHV2
MD-024-060VTDHV2
13.3 Feet (Continuous 48 Watts)
MD-024-192VTHD52JV2
2 X 21.4 Feet (Continuous 77 Watts
each channel)
MD-024-288VTHD52JV2
3 X 21.4 Feet (Continuous 77 Watts
each channel)
RGB+CCT LED FLEX STRIP
Model
: FA60M50-5M-24V-RGBCCT
Copyright © 2022 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).
LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 1.0 - 05/24/22
