4/4
LED FLEX STRIP - Quattro Bright
Model:
FA36M57-2M-12V-X
(X = COLOR W:Pure White / WW:Warm White)
1-800-387-4081
Apply 1 ½” long electrical heat shrink over all connection points. Secure connection wire with wire clamp.
IMPORTANT !
Wrong!
4"
(100mm)
On widest one flat plane (only)
Do not bend sideways.
Flexible on one axis
maximum band radius 4”
TROUBLESHOOTING
Tape light strip does not light
Ÿ
Make sure your power supply is turned on and has the correct voltage.
Ÿ
Conrm you have the correct polarity (+ to + and - and -) throughout the run of LED Lighting.
Ÿ
Have a electrician check all connections and any switch or dimmer connections from the power supply to the LED Light Strips.
Ÿ
Consider testing with a multimeter to ensure light strip is receiving 12V power.
LED Flex Strip lights blink on, then go off
Ÿ
The power supply is not adequate for the length of LED Light Strips you are powering. Install a adequate Class 2 power supply.
LEDs farthest from the power supply are noticeably dimmer
Ÿ
This is the result of voltage drop. Decrease the length of the 12V power feed or use thicker power feed
wires between the 12V power supply and the
lighting strips
.
M60L12DC
8.72 Feet (Continuous 48 Watts)
MAXIMUM FLEXSTRIP LENGTH SUPPORTED BY OUR CLASS 2 POWER SUPPLY
Power Supply
Max Feet of LED Flexstrips
Power Supply
Max Feet of LED Flexstrips
XLD75B-112V-FC
11 Feet (Continuous 60 Watts)
XLD200B-412V-FC
4 X 7.27 Feet (Each Channel)
Total 29 Feet
Dimmable
CONNECT WITH FLEX STRIP CONNECTOR CORD
Another option for quick, easy and exible connection between LED strips is
our Flex Strip Connector Cord. Flex strip Connector Cord are useful option in
application where you want to easily joint light strips over separated surfaces,
between two areas.
+
-
-
+
-
-
Connector Cord
Peel 3M Tape
LED STRIP CUTTING
Our strips comes with cut mark sign. Strips are be cuttable at each 3 LEDs. Cut
marks lying between set of soldering points.
-
-
-
-
CONNECTION OPTION
There are many options available for connecting LED light strips. Right diagram
shows how connect using our Quick Connectors.
However it is strongly recommend to solder the connection. Please refer to our
quick connector instruction sheet.
Note: Peel 3M tape before using with Quick Connectors
+
+
-
-
-
-
-
Quick Connector
Soldered Contacts
Peel 3M Tape
Copyright @2014 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).
LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 1.2 - 09/25/2014
