INSTALLATION INSTRUCTIONS
MODELS:
VarioContour 0002/0005/0013/0016/0022
2
(2)
LED Linear
™
USA, Inc. |
Edition: 30/01/2019
|
LED LINEAR RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS WITHOUT NOTICE
ATTENTION
Please read all safety and assembly instructions prior to installation and keep for future reference.
Field Cutting
Assembling Fixture
Cut extrusion, lens, & mounting channel to the desired length in the field. For
short runs (<78”), cut all parts to the same length by using the proper blades
for aluminum/plastic cut. For longer runs it is recommended to cut the mounting
channel longer than the extrusion to accommodate end to end connections.
Lay mounting channel onto the surface along the pre-determined locations
and secure using the provided screws. Using the mounting bracket is neces-
sary for relevant models ( 002, 004, 005, 007, 013, 016). Gluing the channel
to surface without using the mounting bracket should be avoided. Snap the
channel into the mounting channel. Offset them for longer runs.
4
5
Mounting Channel
Extrusion
Screw
Lens
Extrusion
Extrusion
Screw
Miter Saw
Mounting Channel
Mounting Channel
Assembling Fixture
Installing Endcaps
Installing Lens
Powering
Attach the quick connector or solder lead wires to one side of the tape. Shorten
the LED tape to desired length by cutting along the marked area in between
the solder pads. Remove paper backing from the adhesive tape firmly press
down onto the aluminum surface. Uncoil and peel minimal amount as you
install to avoid collection of debris. Excessive uncoiling and peeling of tape
create ripples and air bubbles on the tape that should be avoided.
Feed the lead wires through or behind the endcap. Add Super Glue inside
and around end cap to secure it in place. For select models, use torque bit
to screw the endcap. If applicable, secure the Quick Connector by adding
super glue and pressing it onto the extrusion.
Snap the diffuser lens into the aluminum extrusion. Remove the protective
film from the diffuser lens.
Ensure the correct (wattage & voltage) power supply is used to power the
tape. Then proceed to connect low voltage wires from extrusion to power
supply. For more information please refer to power supply and LED tape
wiring instructions.
6
8
7
9
Super Glue
Paper Backing
Mounting Channel
End Cap
End Cap
Protective Film
Lens
Extrusion
Low Voltage
Tape in Aluminum Channel
Line Voltage
Class 2
Power Supply
