INSTALLATION INSTRUCTIONS
MODELS:
VarioContour 0002/0005/0013/0016/0022
1
(2)
LED Linear
™
USA, Inc. |
Edition: 30/01/2019
|
LED LINEAR RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS WITHOUT NOTICE
ATTENTION
Please read all safety and assembly instructions prior to installation and keep for future reference.
1.
Product should be installed by a qualified electrician with regards to all applicable electrical and safety standards.
2.
Ensure power is shut off at the electrical panel prior to installation in order to prevent electrical shock.
3.
Use only with SELV (Safety Extra Low Voltage)/Class 2 power supplies.
4.
Suitable for installation in Dry Locations.
5.
Avoid looking directly into the light source during operation - glare hazard.
6.
Do not store packed units over 70° F and over 50% humidity more than 12 months.
NOTE
Prior to installation, always test the LED tape with a suitable power supply in order to confirm operation and that the factory
connections are secure. LED Linear only honors warranty for supplied material and is not liable for installation errors.
Overview
Preparing the Surface
Measuring
Thoroughly clean the area where tape lights will be installed. Using a 50/50
alcohol mix, clean the area where LEDs will be applied and allow time for
alcohol to dry for 5 minutes.
Align the mounting channel to the determined location. Mark reference
points to install to the surface. The location of the power supply or wiring
box should be determined prior to installation.
1
2
3
50/50
ALC
INSTALLATION IN ALUMINUM PROFILE (VarioContour 0002 is illustrated)
End caps and mounting channels are
included with the extrusion order.
(Models 0002, 0005, 0013, 0016, 0022)
Extend wires to a wiring
box or directly to the power
supply.
Mounting channel is
installed along the full
length of the extrusion.
Extrusion mounting channel and lens should be cut
to size separately. Make sure to match lengths and
avoid cracking of the lens.
Place extrusions end to end to extend runs. Offset the mounting
channel to accommodate two extrusions to snap and make
seamless & secure connection.
Reference mark
Mounting Channel
Extrusion
Lens
Reference mark
Reference mark
Measure and then mark
the reference points
