fig. 6
SAFETY SPRING
COLOURS CHANGER
SUPPORTS
FILTERS HOLDER
SCREWS
BLACK OUT
LEVER
HANDLE
COLOURS CHANGER
SYSTEM
fig. 5
To properly adjust the light beam:
•
use the two adjusting screws placed at the back of the lower
cover of the projector together with a descriptive label.
Also, follow what described in the diagram in fig. 1.
3
LAMP
THERMIC
PROTECTOR
LOCKING KNOB
TOP LAMP-HOLDER
SUPPORT
LOWER LAMP-HOLDER
1) Disconnect the unit before replacing the Lamp. Always wear protective gloves and goggles.
2) Unfasten the two knobs placed at the top of the projector (fig. 6).
3) Take out the cover.
4) Take out the two lateral bushes of the new lamp.
5) Unscrew the locking knob of the top lamp-holder (fig. 5).
6) Fasten the lamp in its lower lamp-holder (fig. 5).
7) Screw the locking knob of the top lamp-holder.
8) Put back the top cover and fasten the two knobs.
!
Before mounting the lamp, make sure that into the lamp holder there is not anything that may cause interruptions
to the thermic and electrical conduction.
FITTING
AND
REPLA
FITTING
AND
REPLA
FITTING
AND
REPLA
FITTING
AND
REPLA
FITTING
AND
REPLA
CING
THE
LAMP
CING
THE
LAMP
CING
THE
LAMP
CING
THE
LAMP
CING
THE
LAMP
In
case
of
replacement
of
the
Lamp
or
maintenance,
never
open
the
unit
unless
are
passed
at
least
15
minutes
after
it
went
off.
IMPORTANT
!
Rev.
12
/200
5
Working to make its products always more perfect, LED reserves the possibility to make technical changes during the
production. The technical features and the drawings on this
manual are not binding for LED and they could be changed at any time without notice. LED it is not responsible for any inconven
ience caused by an improper or different use of
the unit respect to the one for what it has been made.
ZOOM AND
FOCUS KNOBS
PROFILE BLADE
PROFILE BLADE
LAMP ACCESS
HATCH KNOBS
HANDLE
IRIS OR
GOBO-HOLDER
!
Before operating any maintenance disconnect the mains.
In case the fan does not correctly work, the FOLLOWSPOT 1200 HMI is equipped with a thermic protector to avoid
any unpleasant inconvenient happening.
For operating a correct maintenance of the FOLLOWSPOT 1200 HMI follow these instructions:
1) periodically clean the in/out air grates;
2) make sure the fan is correctly working;
3) periodically clean the lenses and the reflecting parabole (fig. 5) using antistatic cloths and products.
!
Do not absolutely use solvents or abrasive products.
MAINTENANCE
MAINTENANCE
MAINTENANCE
MAINTENANCE
MAINTENANCE
To avoid any bad performance of the unit or the Lamp breakage
damaging the optics of the FOLLOWSPOT 1200 HMI, replace the
lamp as soon as its maximum average time ends. The lenses
must be replaced when are evidently damaged and if their
efficiency has been reduced, for example from slits or deep cuts.
REFLECTING
PARABOLE
!
Avoid touching the new lamp with the nude hands; in case it accidentally happens, clean the bulb with the
proper tissue given with the replacement lamp.