FLASH-BUTRYM
LED Horizon DMX 203-RGBW User’s Manual - 4 - www.flash-butrym.pl
WARNING
Safety Instructions:
This product guidel contains important information about the safe installation and use of this device. Please read
and follow these instructions carefully and keep this manual in a safe place for future reference.
When unpacking and before disposing of the carton, check there is no transportation damage before using the
device. Should there be any damage caused by transportation, consult your dealer and do not use the device.
The device is for indoor use only. Use only in dry locations. Keep this device away from rain and moisture,
excessive heat, humidity and dust. Do not allow contact with water or any other liquids. The device is not
designed or intended to be mounted directly on to inflammable surfaces.
The device is only intended for installation, operation and maintenance by qualified personnel.
The device must be installed in a location with adequate ventilation, at least 50cm from adjacent wall surfaces.
Be sure that no ventilation slots are blocked.
Do not attempt to dismantle and/or modify the device in any way.
Electrical connection must only be carried out by qualified personnel.
Before installation, ensure that the voltage and frequency of power supply match the power requirements of the
device.
It is essential that each device is correctly earthed and that electrical installation conforms to all relevant
standards.
Do not connect this device to any other types of dimmer apparatus.
Make sure that the power-cord is never crimped or damaged by sharp edges. Never let the power-cord come into
contact with other cables. Only handle the power-cord by the plug.
Never pull out the plug by tugging the power-cord.
The device should always be installed with a secondary safety fixing. A safety cord is supplied for this; it should
be attached as shown in “installing the device” section.
There is no user serviceable parts inside the device do not open the housing and never operate the device with
the covers removed.
This device is not designed for permanent operation. Consistent operation breaks will ensure that the device will
serve you for a long time without defects.
Prevent this product from strong vibration or impact. Don’t use it in shaking conditions.
The maximum ambient temperature ta = 45 °C must never exceeded.
The relative humidity must not exceed 50% with an ambient temperature of 45°C.
If this device is operated in any other way other than the one said in this manual, this device may suffer damages
and thus the warranty becomes void.
