Installation:
!Electrical products can cause death, injury or damage to property. If in any doubt about
the installation or use of this product, consult a competent electrician.
1. Ensure mains supply is switched off before commencing work
2. Before drilling, ensure that the holes will not impinge on joists, pipe work,
cables or other building services
3. Hand dryer must be connected to a circuit controlled by an RCD.
This fitting has no user serviceable parts. If any part is damaged, disconnect from mains
and discontinue use.
Fig 1. Select suitable location: min 15cm free space each
side,50cm free below, lower fixing holes
recommenced 130cm above floor. Please note
that a person using the dryer must not be
obstrucing walkway or door.
Mark wall with appropriate fixing centres.
Fig 2. Remove four screws of the lower shell of the
dryer, and pull the lower shell.
Terminal
Wire-in hole
Fig 3. Install plastic plugs and fix tight the hook with screws. Fix the dryer to
wall and wire to a 13A fused spur outlet, connecting Live(red or brown)
to L, Neutral (blue or black) to N, Green/Yellow to Earth terminal.
Refit cover and test.
Fig 4. When a hand reaches within 15cm rang to the air outlet, the dryer will
sense the hand and automatically start to blow warm air.(The lamp will
also be on at the same time). Hold hands under the nozzle until they are
dry.The hand dryer will stop working after 1 second when the hand
move out of range. The dryer will also stop working after continuous
operation for 60 seconds.
Brown Y./W.
L
N
Blue
128mm
184mm
113.5mm
The Installation must be carried out by an electrician
LED Group
Western Retail Park
Tel: +353 1 7099000
Nangor Road
Fax: +353 1 7099060
Dublin 12
Email: [email protected]
Ireland
Website: www.led.ie
Page 2
ISO 9001:2008
Q UAL IT Y ASSU RED CO MPANY
Australian products are
complete with cable
and Australian plug.