Lectrosonics HMA-941 Series, Инструкция по эксплуатации

Страница: 13 / 20

Plug-on UHF Transmitter
Rio Rancho, NM
13
Step 3:
Refer to Step 1 to return to Firmware web page. Down-
load Firmware Update and save to a local file on your
PC for easy locating when updating.
Step 4:
Open Lectrosonics USB Firmware Updater.
Step 5:
With the unit powered OFF,
put the transmitter in UPDATE
mode by simultaneously
holding down the
UP
arrow,
DOWN arrow, AUDIO and
FREQ
buttons.
Step 6:
Using a microUSB cable, connect the transmitter to
your PC.
Step 7:
In Lectrosonics USB Firmware Updater, choose the
detected device, browse to local Firmware File and click
Start.
NOTE: It may take up to a minute or so for the
Updater to recognize the transmitter.
WARNING: Do not disrupt the microUSB cable during
updating.
The Updater alerts with progress and completion.
Step 8:
Once the Updater has completed, turn off the trans-
mitter, then turn it back on to verify that the firmware
version on the transmitter LCD matches the firmware
version shown on the web site. The firmware is the sec-
ond LCD display during bootup sequence.
Step 9:
Close Updater and disconnect microUSB cable.