Lectranator Systems 27476, Инструкция по установке и эксплуатации

Страница: 5 / 17

4
AUTOPILOT
SANITIZING SYSTEMS
Main Components
Tri-Sensor Assembly
CC-15 Cell(s)
Ball Valve Check Valve
13.8 kpa
2 lb. Spring
Flow In Flow Out
Soft Touch
Control Box
CONTROL BOX converts incoming ELECTROLYTIC SUPERCELL TRI-SENSOR ASSEMB LY
AC power to a Low Voltage DC current, receives Low Voltage DC current from ensures that adequate
which energizes the Cell(s). Set the the Power Circuit Board, which initiates flow , 5.6 m³/hr (25gpm) minimum;
Control Box on a vertical surface away the electrolytic process. This process salt , 2,8 – 3,2 gm/l
from excessive exposure to heat and converts ordinary table salt (Sodium (2800–3200 ppm) ideal range; and
moisture. Use the template to mark and Chloride) to 100% Pure Sodium water temperatures , above
drill the (4) mounting holes and insert Hypochlorite (Chlorine Bleach) or 15.6°C (60

F) are satisfactory to
the screws, leaving a ¼” gap. Hang the Bromine (with the addition of Sodium prevent abusive conditions for the
control box on the screws and level. Bromide), which in turn purifies your cell to operate. See page 10 for
Remove the cover by following the steps pool or spa. instructions to remove and inspect
on page 10 to access the mounting See page 8 for salt requirements. the tri-sensor assembly.
holes to tighten the screws.
RATINGS:
Input Power: 115 VAC (3.0 AC amps) MaximumOutput:Equivalent to 0.91 kg (2.00 lbs) of free available chlorine/day
A minimum of 40,000 ampere/hours
230 VAC (1.5 AC amps) CC-15 CELL @ Cell Power Level 3 (8 amps DC)
50/60 Hz Cell Life Expectancy:
Cell Power 1 (5.0* DC amps) Agency Approvals: NSF, ETL us, ETL c, CE
Cell Power 2 (6.5* DC amps)
Cell Power 3 (8.0* DC amps)
*Indicates nominal amperage output. The dual axis controller will slightly vary the amps to optimize the power to the cell.
The cell and tri-sensor are located in a Patented Automatic Flow Bypass Manifold Assembly. 3.6m (12’) of Cell and Tri-Sensor
cords are provided with the unit. Ensure that the manifold is located within that distance from the control box with enough slack to
allow for removal for service or maintenance.
CAUTION: It is suggested to locate the cell downstream of all other equipment and on the pool return line only to avoid over-
saturation conditions of your spa. For applications other than as recommended, contact the factory.
Section 2a – INSTALLATION
Output Power: