LeCroy DA18000, Инструкция по эксплуатации

Страница: 15 / 34

Operation
DA18000-OM-E Rev A
4-3
Control through the oscilloscope’s interface can be found in the screen menu of the channel
to which the amplifier is connected.
Touching the tab indicating the attached amplifier (in this case DA18000) will activate the
amplifier menu screen. Figure 4-5.
The amplifier information frame shows the characteristics of the amplifier only.
In some applications it may be desirable to turn the amplifier’s AutoColor ID OFF or ON with
touching the Led On frame.
Figure 4-2. Probe menu
CONNECTING THE AMPLIFIER TO THE TEST CIRCUIT
For all modules and interconnect leads, positive voltages applied to the + input relative to
the – input will deflect the oscilloscope trace towards the top of the screen.
2.92 mm Input Cables
The 2.92 mm Interconnect System has been designed to connect directly to female 2.92 mm
connectors as well as to the higher performance 3.5 mm and 2.92 mm female connectors.
The Interconnect Cable connects to the amplifier and the matched pair of SMA Cable con-
nect to the Interconnect Lead.
The connector should be tightnened to a torque of 0.06 Nm (8 in.-oz.).
Note
The 2.92 mm Input Cables are supplied as a matched pair. Individual cables should
not be interchanged between amplifiers.