21
SPRING KIT
When more then 6 treadles are connected to the lams, the weight of the treadles can lift the shaft frames up or
make the movement down very difficult.
To correct this you will have to install springs that will support the weight of each treadle.
Use the screws of the back jack board to install the springs
Make a loop cord knot so the length of the spring with the loop cord will hold the weight of the treadle.
Slide the loop cord end (knot) under each treadle.
It is preferable to always have a small amount of tension on the treadle spring when the treadle is in the
up position.
Install in the back of the jack box the round headed screws (#12, 3/4’’) to anchor the loop cord. Make sure that
each screw align with the treadle.
Used the drill 11/64’’ to make the pre-drill holes.
