Leckey Comfee Seat, Инструкция пользователя

Страница: 5 / 25

Loosen the soft touch knob at top rear
or seat (a). Insert the headrest bars into
receivers at top of seat (b). Adjust to height
required, tighten knob to secure.
To insert speakers (only if you have ordered
optional headrest with speakers) open the
zip at the rear of the headrest. Insert the
speakers into the 2 x pockets in the lining
of the headrest. Pull the speakers cable out
through the rear pocket to connect to your
device which can be stored in the top pocket
of the headrest cover.
Be careful not to trap fingers when
sliding headrest bars into the receivers.
Remove top backrest cushion by pulling
tabs away from poppers at the rear of the
backrest. Align the two holes in lateral
bracket to the slot in the metal plate at the
centre of the backrest (a). Align the washer
between the metal plate and the wood; insert
screw through the rear of backrest through
the full assembly (b). Secure with nut at the
front of the assembly. Note – this is easier to
attach when the seat is tilted backwards. Remove seatbase cushion by pulling tabs
away from poppers underneath the rear
of the seat and lifting cushion off Velcro
strips. Feed the 4 pelvic belt straps through
camlock fittings (a) and clamp to secure.
7.1 Attaching the head
support with or without
speakers 7.2 Attaching the
Flipaway Chest Laterals 7.3 Attaching the 4 point
pelvic belt 7.4 Attaching the tray
Before you insert the tray, make sure the tray
lock lever is unlocked (a). Align tray bars with
the two tray receivers. Push tray into required
position and secure by pulling the tray lock
lever at each side away from each tray bar
(b).
A
A
A
A
B
B B